Made of natural unfinished hemlock.
Rough opening for 36 x 80 pocket door.
You should add 2 1 2 to the height of the actual door.
The rough opening will seem huge.
For fire rated openings drywall must extend at least 1 2 into frame.
X 80 in 32 in.
Jeld wen pocket door frame with frame and hardware.
A opening width 2 b opening height 1 the rough opening would be 38 x 85 for a 3 0 x 7 0 door frame.
The rough opening is the foundation of your system.
While this opening looks very large it must accommodate the door once it slides in the pocket to open.
Make the rough opening for a pocket door two times the width of the door plus 1 inch with a height of 84 1 2 inches from the highest spot on the subflooring.
Get this wrong and you will suffer later.
Framing rough opening sizes are really quite simple.
Reversible can be installed to either side of the door opening.
The rough opening for the pocket door is the rectangle created by the wall studs.
Just add 2 to the width of the actual door size.
This domestically produced pocket door frame includes the track installation hardware and instructions.
Add 2 to 2 1 2 inch to the measurement of the door s width to determine the total width of the rough opening.
Factory primed ready for paint.
It s a very specific height and width both called out in the written pocket door installation instructions.
The difference between a rough opening and finished opening is usually 2 3 inches.
D attach guides 1550 at bottom of opening and adjust so door is centered in opening.
Pocket door hardware 2 x 4 wall pocket door frames.
Refer to the charts below to determine what size of door you will need.
Adjust hangers 1120 for height and plumb with jamb.
X 80 in 30 in.
Getting the rough opening size right the first time will save you from frustration when installing your doors.
15113068 stain grade pocket door jamb kit.
X 80 in 28 in.
This will give you room to space the door frame off of the sub floor.
This takes into account the thickness of a standard 3 4 inch doorjamb on each side.
Repeat with other hanger door plate.
1555ppk3 converging door kit.
C mount door by locating door plate 1121 under adjusting bolt of hanger 1120 and tilting door until bolt will slide into seat of door plate 1121.
While a standard door height is 80 finished opening.
If you have questions give us a call at 888 458 5911.
36 x 80 x 4 9 16 max.