Ptac Wall Sleeve Installation Instructions

To ensure proper airflow and filter removal it is recom mended installation of the wall sleeve be a minimum of 36 from the ceiling.

Ptac wall sleeve installation instructions.

For new installs ensure the wall is properly framed to support the weight and dimensions of the wall sleeve and air conditioner. Tools required by. This information might be about you your preferences or your device and is mostly used to make the site work as you expect it to. While the dimensions may appear to be incompatible the 2 devices should fit properly.

For sunrooms and modular buildings adhere to their installation instructions for supporting and sealing sleeve to their frames. Standard steel wall cases are 42 w 16 h 13 3 4 d. Inches mm inches mm inches mm wall sleeve only 3 75 0 0 0 0 subbase kit 3 75 3 1 4 85 2 3 4 70. Wall case must be sealed caulked to outside wall on all four 4 sides.

The wall sleeve must be fastened securely before installing the air conditioner unit. Consult a licensed contractor as needed. Figure 4 minimum interior and exterior note. When you visit any website it may store or retrieve information on your browser mostly in the form of cookies.

If the sleeve projects more than 8 into the room a sub base or other means of support must be used. Wall sleeve installation 920 087 04 8 05 wall sleeve installation instructions pdxws note. Failure to install and maintain our product according to these instructions may void any product warranty. See the drain kit for internal actual installation instructions.

Insure that the unit is only installed in a wall structurally adequate to support the unit including the sleeve chassis and accessories. Installation guidelines for sealing ptac sleeves read these instructions completely before starting any installation. All wall and window wall installations must provide for proper drainage. 16 24 28 and 31 deep cases are available for thicker walls.

In applications where the drain holes on the ptac wall sleeve are not exposed beyond the wall an internal drain system is recommended. The air conditioner will slide into the sleeve but is not flush with the wall. In applications where the drain holes on the ptac wall sleeve are not exposed beyond the wall an internal drain system is recommended. Wall case should be sealed caulked to the inside wall on all four 4 sides.

Prepare and install the new wall sleeve according to the instructions below. When a drain kit is to be installed do so before top of wall sleeve installing the wall sleeve in the wall. All wall and window wall installations must provide for proper drainage. The wall sleeve be installed a minimum of 36 from the ceiling.

There is a portion of the air conditioner which extends a few inches back into the room.